Currently viewing: HOME > Wrangler JK 2007-2018 > Electrical > Panels
Sort By:
Page of 1
Daystar Jeep JK Wrangler 07-10 Switch Panel Daystar Jeep JK Wrangler 11-12 Switch Panel Daystar Jeep JK Wrangler 07-10 Upper Dash Panel
Daystar Jeep JK Wrangler 07-10 Switch Panel
MSRP: $39.00
Price: $19.99 Guaranteed in stock!
Save $19.01!
Daystar Jeep JK Wrangler 11-12 Switch Panel
MSRP: $39.00
Price: $19.99
Save $19.01!
Daystar Jeep JK Wrangler 07-10 Upper Dash Panel
MSRP: $39.00
Price: $23.99 Guaranteed in stock!
Save $15.01!
This front lower center dash panel will directly replace the existing OE panel allowing you to install 1 to 4 Rocker Switches This front lower center dash panel will directly replace the existing OE panel allowing you to install 1 to 5 Rocker Switches This new dash panel will directly replace the existing OE dash panel allowing you a place to hold your cell phone, GPS unit, sunglasses, etc.
Switch Pros SP-8100 8-Switch Panel Power System
Product Description:

  • Eight user-programmable switches
  • User-selectable switch legends
  • Illuminated switches with user-adjustable brightness
  • Programming and control via panel or smart phone
  • Bluetooth interface
  • 100A solid state power module, engine compartment rated
  • Automatic shutdown for overcurrent and low voltage
  • Programming options are: On/Off or Momentary, Ign. or Batt., Flash and Strobe functions, Low Voltage Disconnect, and Switch Memory
  • Plug and play installation
Switch Panel Specs:
  • 4L x 2W x .5H (excluding tabs)
  • Enclosure: Anodized Aluminum
  • Orange LED switch indicators
  • Green backlighting
  • 4 interface cable
Power Module Specs:
  • 6L x 3W x .5H (excluding connectors)
  • Enclosure: Anodized aluminum
  • 8 Outputs, 7 rated @ 18A, 1 rated @ 30A
  • 100A maximum rating 125C to -40C
  • 16-pin, sealed automotive connector, wire harness w/100A fused power cable, light, and ignition input wires, and eight 3long output wires
Switches can be programmed to be: On/Off or Momentary, ignition or battery powered, flash, strobe, low voltage disconnect, and memorize previous settings. There is also a programming function to adjust the brightness of backlighting and indicator LEDs.